9
Installation
PREP
ARA
TION
5
4
3
1
2
6
Bend the claws
according to
the thickness
of the
dashboard
A
A
Basic Installation
Before installing, make sure that the ignition-switch is set to OFF and
remove the terminal of the car battery to avoid short-circuiting.
1. Remove the existing receiver unit.
2. Make the necessary connections.
3. Install the installation sleeve.
4. Install the unit in to the installation sleeve.
Removing existing receiver unit
If there is already an installation sleeve for the receiver unit in the dash-
board, it must be removed.
When removing the unit from the installation sleeve
If you need to remove the unit from the installation sleeve,
proceed as follows.
1. Remove the rear supporter from the unit.
2. Remove the front panel and trim ring from the unit.
3. Insert the lever
into the hole on one side of the unit. Do the same
operation on the other side and pull out the unit from the installation
sleeve.
ISO-DIN Installation
1. Slide the unit into ISO-DIN frame.
2. Install screws removed from old unit.
3. Slide the unit and frame into dash opening.
4. Install dash panel or adapter plate.
5. Install trim ring to the unit.
6. Install faceplate by fitting right edge into position then pushing left edge
closed.
A
