- 2 -
O
Deflection Data Adjustment (Line SVC-1)
NOTE: To enter SVC mode, press "OK" buttons on both TV set
and the Remote control at the same time.
1. Preparation for Deflection Adjustment
1) At SVC mode, press the Yellow colored button.
If the Remote Controller doesn't have the Yellow button, you
should use a Service Remote Control (105-201G) and press
SVC button.
And then, deflection data adjustment OSD (SVC1 mode) will
be displayed.
2) Press Channel UP/DOWN button for desirous function
Adjustment.
3) Press Volume UP/DOWN button to adjust the data.
4) Press OK button to memorize the adjusted data before exit
the SVC Mode.
2. Deflection Adjustment Procedure
VL (Vertical Linearity)
Adjust so that the boundary line between upper and lower
half is in accord with geometric horizontal center of the CPT.
VA (Vertical Amplitude)
Adjust so that the circle of a digital circle pattern may be
located within the effective screen of the CPT.
SC (Vertical “S” Correction)
Adjust so that all distance between each horizontal lines are
to be the same.
VS (Vertical Shift)
Adjust so that the horizontal center line of a digital circle
pattern is in accord with geometric horizontal center of the
CPT.
HS (Horizontal Shift)
Adjust so that the vertical center line of a digital circle
pattern is in accord with geometric vertical center of the
CPT.
EW (Horizontal Width)
Adjust to that a digital circle pattern looks like exact circle.
EP (East-west Parabolar)
Adjust so that middle portion of the outermost left and right
vertical line looks like parallel with vertical lines of the CPT.
EC (East-west Coner)
Adjust so that the vertical line at every 4 corners of the
screen looks like parallel with the vertical lines of the CPT.
ET (East-west Trapezium)
Adjust to make the length of top horizontal line same with it
of the bottom horizontal line.
VZ (Zoom Mode, Vertical Height)
Select the zoom mode with ARC button and adjust the data
until the lines “a” and “b” of figure are 3~5mm from the top,
bottom and each sides of CPT.
O
White Balance Adjustment.(LINE SVC-0)
NOTE : This adjustment should be performed after screen voltage
adjustment.
1) Tune the TV set to receive an 100% white pattern.
2) Press OK(
Y
) buttons on TV set and remote controller at the
same time to get into SVC mode.
3) Press PSM(RED) button on remote controller. (Standard
picture)
4) Press Channel UP/DOWN button for desirous function
adjustment.
5) Adjust VOL+ or VOL- button for GG:31.
6) Adjust VOL+ or VOL-button in each status of "Rg--"/"Bg--" for
X=283
!
8, Y=295
!
8 with color analyzer.
7) Press OK(
Y
) button to memorize the adjusted data.
a
b
<Figure>
