Figure 8
3-4 FAN AND FAN MOTOR
1. Remove the freezer shelf.
2. Separate the Guide Ice Tray by pulling right.
3. Loose 1 screw.
4. Pull out the Grille Fan and Shroud-F.
Figure 10
3-3 THERMOSTAT
1. Remove the Cover Lamp-R by the use of ‘_’ type driver
inserting in the low holes of the cover.
2. Loose 2 screw.
3. Pull the Control Box-R.
4. Disconnect the Housing of lead wire.
5. Separate the INSU’MultiDuct and Control Box-R.
6. Diassemble the Knob
.
7. Separate the Thermostat and Control Box-R.
8
. Disconnect the lead wire.
3-2 DOOR SWITCH
3-1 DOOR
Freezer Door
Separating the Hinge Upper.
Close
the freezer door and remove the Hinge
Cover
and
then
unscrewing 2
bolt
s. In this case, be careful not
to
drop the freezer door. (Figure 6)
Separating the Freezer Door.
2.
Refrigerator Door
1. Loosen hexagonal bolts fixing the Lower Hinge to the
2. Pull out the door gasket to remove from the door foam
Ass'y.
- 6 -
1.
Open the freezer door to 90
after separating the Hinge
Upper,
and grasp the
Freezer Door
with
right
hand.
Slide the freezer door to the
upside
after
remove the
O
Hinge Upper from the ceiling of the refrigerator, and
separate the freezer door by lifting it up. (Figure 7)
body to remove the refrigerator door only.
1. To remove the door switch, pull out it with a ‘_’ type
driver as shown in (figure 9).
2. Disconnect the lead wire from switch.
3. DISASSEMBLY
BOLT
HINGE
HINGE
COVER
Figure
6
LOWER
HINGE
BOLT
Figure
11
Figure 9
Figure
7
Figure
10
INSU
'
MULTI
DUCT
THERMOSTAT
CONT
'
BOX
‑
R
KNOB THERMOST
A
T
COVER
LAMP
‑
R
