LG GDC-345H, Manual, Page: 7 / 10

LDK-24 WOTS
GDC-345H Factory Mode Manual
ISSUE 1.0
7/10
3.1. Entering
It can be possible to enter into ‘ LGGAP mode ’
through the main menu. Please, for detail for
main menu, refer to GDC-345H User Guide.
Press MENU(UP( ) or DOWN( )) button, then
main menu will be displayed as left.
Press button to enter into ‘ LGGAP Mode ’ .
When LCD is displayed like left, input password to
enter into LGGAP mode.
The FAC. CODE is ‘ 54427 ’ .
After input ‘ 54427 ’ , press OK button.
In case of successfully entering into ‘ LGGAP
mode ’ , LCD is displayed as left. If the password is
not exact, LCD returns to main menu.
You can select a submenu alternative of direct
selection or scroll selection. When you use direct
selection, press directly number button refer to
above menu tree. When you use scroll selection,
press repeatedly MENU(UP( ) or DOWN( ))
button until the cursor(>) goes to where you want to select. And press OK button.
Then, it enters into submenu you want.
3.2. Exiting
To exit from ‘ LGGAP mode ’ or any submenu, press ‘ C/R ’ button repeatedly until ‘ Idle
State ’ is displayed. Or, press PWR button more than 1 second.
3.3. Version
This submenu shows you the software version of
GDC-345H and creation date.
The version and date may different from that of
left.
3.4. Reset
This submenu enables you to clear the EEPROM of
GDC-345H. If you want initialize all data of
EEPROM, press OK button. Else press C/R button
to cancel.
If once clearing is started, you cannot abort. And
all data will be deleted except data related to
hardware control parameter. Therefore, you have
F A C . C O D E
1 > V e r s i o n
2 R e s e t
P S T 2 . 0 D
2 0 0 4 . 0 6 . 1 9
C L E A R
E E P R O M ?
1 > H S S e t t i n g
2 K e y L o c k