How to use washer
Tub Clean is a special cycle to clean the inside of the washing machine.
A higher water level is used in this cycle at higher spin speed. Perform this cycle regularly.
1
. Remove any clothing or items from the
washer and close the door.
2
. Open the dispenser drawer and add Anti
limescale(e.g. Calgon) to the main wash
compartment.
3
. Close the dispenser drawer slowly.
4
. Power On and then touch and hold Tub
Clean button for 3 seconds. Then ' ' and
tub clean pictogram will be displayed on the
LED display.
5
. Touch the Start/Pause button to start.
6
. After the cycle is complete, leave the door
open to allow the washer door opening,
flexible gasket and door glass to dry.
“Door Lock”
- For safety reasons, the
door will lock while machine is in use and the
“Door Lock” icon will light up. You can safely
open the door after the “Door Lock” icon
turns off.
While
"Detecting"
is shown on the
display the washing machine rotates slowly
and detects how much laundry is loaded in
the drum.
It will take a short time.
Tub Clean ( )
Door Lock & Detecting
NOTE
Do not add any detergent to the detergent compartments.
Excessive suds may generate and leak from the washer.
CAUTION
If there is a child, be careful not to leave the door open fo r too long.
Summary of Contents for F J5NNW Series
