LG DLEX5000V, Owner'S Manual

Page: 49 / 109

48
Before Calling for Service (cont.)
Problem Possible Causes Solutions
Steam does not
generate but
no error code is
shown
• Water level error. • Unplug dryer and call for service.
Garments still
wrinkled after
STEAM FRESH™
• Too many or too different types
of garments in dryer.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
There are no
creases left on
garment after
STEAM FRESH™
• The function of this cycle is to
remove wrinkles from fabric.
• Use an iron to make creases.
Water drips from
door during
Steam Cycle
• This is normal. • Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
Steam is not
visible during
Steam Cycle
• This is normal. • Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the
inside of the dryer door if the steam system is operating
normally.
Drum does not
turn during
Steam Cycle
• This is normal. • The drum is turned off so that the steam vapor remains
in the drum. The drum will normally turn for about 2
seconds once a minute.
Cannot see
steam vapor at
the beginning of
cycle
• This is normal. • Steam is released at different stages of the cycle for each
option.
The display
shows
• MORE TIME button pressed. • This display indicates that the steam option has been set
for a “ ” item such as a comforter.
Press the LESS TIME button to reduce the indicated load
size.
Odors remain
in clothing after
STEAM FRESH™
• STEAM FRESH™ did not remove
odor completely.
• Fabrics containing strong odors should be washed in a
normal cycle.
CHECK FILTER
light is on during
the drying cycle
• Lint filter is almost clogged or
full.
• Pause the drying cycle and clean the lint filter.
FLOW SENSE
TM
indicator shows
four bars during
the drying cycle
or the display
shows “d80” after
drying.
• Ductwork is too long or has too
many turns/restrictions.
• Significant blockage of the
ductwork due to lint buildup or
debris.
• The appliance has detected a
restriction in the external dryer
venting.
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the Flow Sense
TM
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
Power button will turn off the display.
TrOuBLEShOOTiNg