36
hoW to UsE
Custom program
If you have a special combination of settings that you use
frequently, you can save these settings as a custom program.
* to save a custom program:
1. Turn on the dryer and turn the cycle selector knob to select the
desired cycle.
2. Use the cycle setting buttons to adjust the settings for that
cycle.
3. Press the cycle option button(s) for the option you would like to
add. A confirmation message will be shown in the display.
4. Press and hold the CUSTOM PROGRAM button for 3 seconds.
to recall a custom program:
1. Turn on the dryer.
2. Press the CUSTOM PROGRAM button to select the saved cycle.
3. Press the START/PAUSE button to start the cycle.
Steam functions
to fill the steam feeder
1. Pull out the drawer.
2. Lift out the steam feeder.
3. Fill the steam feeder just to the filter screen.
4. Place the steam feeder in the drawer; then push in the drawer
until it clicks into place.
w
WarnInG
•
Do not fill the steam feeder with liquids such as gasoline,
dry-cleaning solvents, or other flammable or explosive
substances.
Failure to follow this warning can cause serious
injury or death.
•
Do not drink water from the steam feeder.
Failure to follow
this warning can cause serious injury or death.
Drawer
Water
ONLY
Steam
Feeder
notE
You may save only one custom program at a time. Pressing
and holding the CUSTOM PROGRAM button will overwrite any
previously saved custom program.
notE
Before using a Steam Cycle, the steam feeder must be filled
with water up to the MAX line. If not, the will be
displayed. Make sure that the steam feeder is filled with water
or the drawer is fully closed. Turn the dryer off then restart the
steam cycle.
• Only use water. Do not fill the steam feeder with foreign
substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam feeder is
empty.
• Do not use distilled water; the water level sensor in the steam
generator will not work.
• Be careful to put the Steam Feeder otherwise water will be
overflow.
• Wipe up any spilled water around the Steam Feeder and the
drawer before starting the dryer.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
MFL62512860_en_111220.indd 36
2011.12.20 11:21:10 AM
