6
SAFETY INSTRUCTIONS
•
Place the dryer at least 18 inches above the floor for a garage installation.
•
Do not use sheet metal screws or other fasteners which extend into the duct that could catch lint and reduce
the efficiency of the exhaust system. Secure all joints with duct tape.
•
Use only rigid, semi-rigid or flexible metal 4-inch diameter duct inside the dryer cabinet or for exhausting to
the outside. Use of plastic or other combustible ductwork may cause a fire. Punctured ductwork may cause
a fire if it collapses or becomes otherwise restricted in use or during installation.
•
The exhaust duct must be 4 inches (10.2 cm) in diameter with no obstructions. The exhaust duct should be
kept as short as possible. Make sure to clean any old ducts before installing your new dryer.
•
Rigid, semi-rigid or flexible metal ducting is recommended for use between the dryer and the wall. All non-
rigid metal transition duct must be UL-listed. Use of other materials for transition duct could affect drying
time.
•
Ductwork is not provided with the dryer, and you should obtain the necessary ductwork locally. The end cap
should have hinged dampers to prevent backdraft when the dryer is not in use.
•
Gas dryers MUST be exhausted to the outside.
•
The dryer exhaust system must be exhausted to the outside of the dwelling. If the dryer is not exhausted
outdoors, some fine lint and large amounts of moisture will be expelled into the laundry area. An
accumulation of lint in any area of the home may create a health and fire hazard.
•
Do not install near another heat source such as a stove, oven or heater.
•
Keep area around the exhaust opening and adjacent surrounding areas free from the accumulation of lint,
dust, and dirt.
•
The appliance must not be supplied through an external switching device, such as a timer, or connected to
a circuit that is regularly switched on and off by a utility.
OPERATION
•
If the power cord is damaged, it must be repaired by the manufacturer or its authorized service agent. Do
not use a cord that shows cracks or abrasion damage along its length or at either end.
•
If you detect a strange sound, a chemical or burning smell, or smoke coming from the appliance, unplug it
immediately, and contact an LG Electronics customer information center.
•
Never unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out
from the outlet.
•
Do not use an extension cord or adapter with this appliance.
•
Do not grasp the power cord or touch the appliance controls with wet hands.
•
Do not modify or extend the power cord.
•
If the product has been submerged, contact an LG Electronics customer information center for instructions
before resuming use.
•
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
•
Keep the area underneath and around your appliances free of combustible materials (lint, paper, rags, etc.),
gasoline, chemicals and other flammable vapors and liquids.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety.
Summary of Contents for DF22BV2BR
Page 56: ...54 MEMO ...
Page 110: ......
