- 10 -
DISASSEMBLY
1. TILT/SWIVEL REMOVAL
Set the monitor face down.
Pressing the latch
, carefully remove the Tilt/Swivel
by pulling it upward.
2. BACK COVER REMOVAL
Remove four screws
from the Back Cover.
Slide the Back Cover away from the Front Cabinet
of the monitor.
3. TOTAL CHASSIS ASSEMBLY REMOVAL
Disconnect P901 (Degaussing pin), P701
(H-DY pin), and P601 (V-DY pin).
Remove two screws
from the Rear Bracket to
remove the Ground Wire of the CRT.
Remove two screws
from the Main Bracket to
separate it from the Front Cabinet.
4. CRT BOARD ASSEMBLY REMOVAL
Remove three pins
.
Remove CRT ground connector
Carefully separate the CRT Board Assembly from
the CRT neck.
Discharge the remaining static electricity by shorting
between the Anode Cap and the CRT ground.
Disconnect the Anode Cap from the CRT.
Anode Cap
