5. Replacing the Lamp
(1) Turn off the projector and unplug the power cable.
Carefully place on a cushioned surface.
(Allow the lamp to cool for 1 hour before removing the used lamp from the projector.)
(2) Unscrew the screw from the lamp cover using a screwdriver.
(3) After lifting the lamp cover off, remove the two retaining screws on the lamp case with a screwdriver.
(4) Lift the lamp up from the projector.
(5) Pull out the handle slowly and remove the lamp case.
(6) Insert the new lamp gently into the correct position.
Make sure it is inserted correctly.
(7) Tighten the screws you removed in step 3.
(Make sure they are fixed firmly.)
(8) Close the lamp cover and install the screws from step 2 to install the cover.
(If the lamp cover is not installed correctly the unit will not power on.)
[Note]
Using another manufacturers lamp may cause damage to the projector or lamp.
Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on.
If this fault persists contact an LG Authorized Service Center.
- 5 -
Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Lamp case screw
Knob
Screw
Summary of Contents for BX401C
Page 39: ......
