5
ENGLISH
2
Installing Anchors
- Using the hole-drilling template provided, mark the positions of the anchor holes shown on the drawing in the
wall; using a centre-punch or other device to clearly identify the 10 drill hole positions.
Note: It is advisable to use a bubble level to make sure that the template is horizontally true.
- Warning: The surface that the tilt wall mounting bracket is to be mounted on should be of sufficient strength to
support the weight of the monitor and speakers typically; concrete, strong/weak natural rock, brick and hollow
block.
- Warning: Plasterboard is not a sufficiently strong enough material; unless the bolts are anchored into standard
construction type studs capable of supporting the weight of the monitor and speakers. If you can not
determine the strength of the material, each drilled hole should be capable of supporting a normal stress level
of 70kgf (686N) and shear stress 100kgf (980N).
Keep these instructions for future reference
Keep these instructions for future reference
a
b
d
e
a. Using an 8mm drill appropriate for the material on the wall, drill each hole to a depth of 80mm/3.15inches –
100mm/3.94inches.
b. Clean each drilled hole.
c. Insert an anchor supplied with the tilt wall mounting bracket into each hole.
d. Mount the tilt wall mounting bracket on the wall. And push the guide control part upward.
e. Assembled in holes carefully. At this time, tighten the bolt to over 45kgf
∙
cm of torque.
Bolts for tilt wall mounting bracket
c
Anchor
