Installation Manual
9
Installation
ENGLISH
Set screw of
paper pattern (4 pieces)
Paper pattern
for installation
90 mm
Adjust the
same height
Ceiling board
Ceiling
Flat washer for M10
(accessory)
Keep the length of the bolt
from the bracket to 40 mm
Open the ceiling board
along the outer edge of the
paper pattern
Flat washer for M10
(accessory)
Hanging bolt
(W3/8 or M10)
Nut
(W3/8 or M10)
Nut
(W3/8 or M10)
Air Conditioner body
Ceiling board
Ceiling board
Ceiling board
• The following parts are local purchasing.
①
Hanging Bolt - W 3/8 or M10
②
Nut - W 3/8 or M10
③
Spring Washer - M10
④
Plate Washer - M10
Terminal Block
Indoor
Terminal
Block
Indoor
Terminal Block of outdoor unit
1(L) 2(N)
3
4
INDOOR POWER INPUT
B
SODU
IDU
INTERNET DRY1 DRY2 GND 12 V
B
A
A
B
A
-
-
-
-
Outdoor unit
Connect the wires to the terminals on the control board individually according to the outdoor unit connection.
• Ensure that the color of the wires of outdoor unit and the terminal No. are the same as those of indoor unit
respectively.
WARNING
Make sure that the screws of the terminal are free from looseness.
CAUTION
The Power cord connected to the unit should be selected according to the following
specifications.
CAUTION
The connecting cable connected to the indoor and outdoor unit should be complied with the
following specifications (This equipment shall be provided with a cable set complying with the
national regulation).
If the supply cable is damaged, it must be replaced by a special cable or assembly available from
the manufacturer of its service agent.
!
!
!
CAUTION
Tighten the nut and bolt to prevent the
unit from falling.
!
Wiring Connection
