LG ABUQ09GL1A0, Installation Manual

Page: 15 / 37

Remote Controller Installation
Installation Manual 15
ENGLISH
Operation un
it
ZONE
1 2 3
4
Humi dify
JET
AUT O
AUT O SWING
OPERA
TION
FA N SPEED
Progr am s
et
SUB FUNCTION
SET TEMP
Room
Te mp
HI
MED
LO
Heater
Defrost
Filt
er
Preheat
Out door
Ti m
e
Ti mer
On
Set no. Tim
e Of f 01
03 05
07
09
11 13
15
17 19
21
23
5feet
(1.5meters)
Direct
Sun ray contact area
no
no
no
yes
Operation
un
it
ZO
NE
1 2
3 4
Humidify
JET AUT
O
AUT
O SWING
OPER
AT ION
FAN SPEED
Pro gra
m set
SUB FUNCTION
SE
T T EM P
Room Te mp
HI
MED
LO
Heater
Defrost
Filter
Preheat
Out door
Ti
m e
Ti mer On
Set no. Tim e Of f 01
03
05
07 09
11
13 15
17
19 21
23
Fig.1 Typical locations for remote controller
Wireless Remote Controller
HOW TO MOUNT ONTO A WALL
HOW TO INSERT BATTERIES
1. Remove the battery cover from the remote
controller.
• Slide the cover according to the arrow direction.
2. Insert the two batteries.
• Be sure that the (+) and (-) directions are
correct.
• Be sure that both batteries are new.
3. Re-attach the cover.
• Slide it back into position.
• Do not use rechargeable
batteries, such batteries differ
from standard dry cells in
shape, dimensions, and
performance.
• Romove the batteries from the
remote controller if the air
conditioner is not going to be
used for some long time.
• Since the room temperature sensor is in the remote controller, the remote controller box should be installed
in a place away from direct sunlight, high humidity and direct supply of cold air to maintain proper space
temperature. Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation
at an average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of the remote
controller LED's, the remote controller should be installed properly as shown in Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
Wired remote controller installation