LG ABNW24GM1S1, Installation Manual

Page: 16 / 30

3
Please fix remote controller upper part into
the backplate attached to the surface of
the wall, as the picture below, and then,
connect with backplate by pressing lower
part.
- Please make sure to leave no gaps on the
top, bottom, left or right sides between
the remote controller and backplate.
- Before assembly with the backplate,
arrange the Cable not to interfere with
circuit parts.
Remove remote controller by inserting a
screwdriver into the lower separating holes
and twisting to release the controller from
backplate.
- There are two separating holes. Please
individually separate one at a time.
- Please be careful not to damage the
inside components when separating.
4
Please refer to the following directions
when connecting the indoor unit and the
wired remote controller together.
- Please connect the cables as shown in
the figure below when connecting the
plug type cable from the indoor unit’s
C/BOX and the housing type of the
extension cable.
5
Please use an extension cable if the distance
between the wired remote controller and the
indoor unit is longer than 10 m(32 ft).
16
INSTALLATION INSTRUCTION
ENGLISH
Wall
Side
Wall
Side
<Connecting order>
Please check if the connectors
are connected properly.
C/BOX Cable (Plug type)
Extension cable(housing type)
Indoor
Unit side
Wall
Side
Wall
Side
<Separating order>
Signal Yellow
12 V Red
GND Black
CAUTION
!
CAUTION
!
• Specification of LG supplied extension
cable: AWG#22, 3 core shielded.
(Model : PZCWRC1)
* Apply enclosed noncombustible
conduit(metal raceway) totally or use FT-
6 rated cable or above level in case of
local electric & building code that
requires plenum (CMP) cable usage.
• AWG#22, 3 core shielded is
recommended when using the large hole
in the center of the back plate.
• AWG#24, 3 core shielded is
recommended when using the side or
top knock-out of the back plate.
• When installing the wired remote
controller, do not bury it in the wall. (It
can cause damage in the temperature
sensor.)
• Do not install the cable to be 50 m(164 ft)
or longer. (It can cause communication
error.)