29
ENTERTAINMENT
ENGLISH
2
Press the red ON button on the remote
control to assign the
PICTURE ID
.
1
Assign the
Set ID
to the installed monitors
as shown below
.
3
Assign the
Set ID
to the selection of your
choice.
•
A set with a different
Set ID
from the
Picture
ID
cannot be controlled by IR signals.
Picture ID Settings
Picture ID
is used to change the settings of a
specific set (display) using a single IR receiver
for multi-vision. Communication is possible
between a monitor with an IR receiver and
other monitors using RS-232C cables. Each
monitor is identified by a
Set ID
. If you assign
the
Picture ID
using the remote control, only
displays with matching
Picture ID
and
Set ID
can be controlled remotely.
•
If
Picture ID
is set to 2, only the upper right
monitor, which has a
Set ID
of 2, can be
controlled by IR signals.
•
If you press the green
OFF
button for
PICTURE ID
, the
Picture ID
s for all
monitors are turned off. If you then press
any button on the remote control, all
monitors can be controlled by IR signals
regardless of
Set ID
.
•
With
PICTURE ID
ON, you can only
increase the
picture ID
by 1. You cannot
decrease it.
NOTE
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
IR and Light Sensor
RS-232C Cables
PICTURE ID ON [2]