5.5 EYE-Q function check
Step 1) Turn on TV
Step 2) Press EYE key of Adj. R/C
Step 3) Cover the Eye Q II sensor on the front of the using
your hand and wait for 6 seconds
Step 4) Confirm that R/G/B value is lower than 10 of the
“Raw Data (R: G: B: )” .
If after 6 seconds, R/G/B value is not lower than 10,
replace Eye Q II sensor
Step 5) Remove your hand from the Eye Q II sensor and wait
for 6 seconds
Step 6) Confirm that “B. Light(xxx)” value increases from 0.
If change is not seen, replace Eye Q II sensor
< step 2> < step 3> < step 4>
< step 5> < step 6>
5.7 Ship-out (Default) mode check (Instop)
• After final inspection, press In-Stop key of the Adjustment R/C
and check that the unit goes to Stand-by mode.
• After final inspection, Mechanical S/W(AC S/W) to the “on”
position.
6. GND and Internal Pressure check
6.1 Method
1) GND & Internal Pressure auto-check preparation
- Check that Power Cord is fully inserted to the set
(If loose, re-insert)
2) Perform GND & Internal Pressure auto-check
- Unit w/ fully inserted power cord and A/V arrives to the auto-
check process.
- Connect D-terminal AV JACK TESTER
- Auto CONTROLLER(GWS103-4) ON
- Perform GND TEST
- If NG, Buzzer will sound to inform the operator
- If OK, changeover to I/P check automatically
(Remove CORD,A/V from AV Jack Box)
- Perform I/P test
- If NG, Buzzer will sound to inform the operator
- If OK, Good lamp will lit up and the stopper will allow the
pallet to move on to next process.
6.2 Checkpoint
• TEST voltage
- GND: 1.5KV/min at 100mA
- Signal: 3KV/min at 100mA
• Test time: 1 second
• Test point
- GND test = Power cord GND & signal cable metal GND
- Internal pressure TEST = POWER CORD GND & LIVE &
NEUTRAL
• LEAKAGE CURRENT: At 0.5mArms
7. USB S/W Download (option)
7.1 Overview
•USB download allows fast SW upgrade in SVC areas or
during Board-level production
7.2 Download Method
1) After set on, confirm that image is displayed
2) Insert USB memory stick that contains the SW and after
few seconds similar image to the picture below will appear
3) In [Current TV Software Version Information] confirm
current version, and in [New Found TV Software Version
Information] confirm to-be version then press Enter by
selecting Start
4) Progress bar will appear as below and after completion,
the set will reset (if the process does not advance to the
picture below, reset the unit and repeat the steps)
5) After download is complete, remove USB memory stick
6) By pressing In-Start on the adj. R/C, check the version
- 18 -
LGE Internal Use Only
Copyright LG Electronics. Inc. All right reserved.
Only for training and service purposes
C
2009
TV Software Upgrade
INFORMATION
MODEL
Current ver.
Update ver.
LU-FHD 128
Ver. 3.00
Ver. 3.01
47LH40-UA-v0301.epk
START
CANCEL
Press arrow key to move to the Start and....
TV Software Upgrade
Do not unplug until restart automatically
UPGRADING....
25%
TV Software Upgrade
Do not unplug until restart automatically
UPGRADING....
COMPLETE
