27
ENTERTAINMENT
ENGLISH
2
. Press the red ON button on the remote
control to assign the
PICTURE ID
.
1.
Assign the
Set ID
to the installed monitors as
shown below
.
3.
If you press the left/right buttons or the red
ON
button for
PICTURE ID
repeatedly, the
Picture ID
toggles between
OFF
and 1 to
255. Assign the
Set ID
to the selection of
your choice.
•
A set with a different
Set ID
from the
Picture
ID
cannot be controlled by IR signals.
Picture ID Settings
Picture ID
is used to change the settings of a
specific set (display) using a single IR receiver
for multi-vision. Communication is possible
between a monitor with an IR receiver and
other monitors using RS232C cables. Each
monitor is identified by a
Set ID
. If you assign
the
Picture ID
using the remote control, only
displays with matching
Picture ID
and
Set ID
can be controlled remotely.
•
If Picture ID is set to 2, only the upper right
monitor, which has a Set ID of 2, can be
controlled by IR signals.
•
If you press the green OFF button for
PICTURE ID, the Picture IDs for all
monitors are turned off. If you then press
any button on the remote control, all
monitors can be controlled by IR signals
regardless of Set ID.
•
The Picture ID function may not work while
My Media is operating.
NOTE
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
IR & Light Sensor
RS232C cables
PICTURE ID ON [2]
