- 8 -
(4) Push the “Write Data & Verify” button. And confirm “Yes”.
(5) If the writing is finished, you will see the “ OK” message.
5. HDCP
(High-Bandwidth Digital Contents Protection)
(1) Connect D-sub Signal Cable to D-Sub Jack
(2) Input HDCP key with HDCP-key- in-program
(3) HDCP Key value is stored on EEPROM(AT24C512) which
is 80~A1 addresses of 0xA0~0xA2 page
(4) AC off/ on and on HDCP button of MSPG925 and confirm
whether picture is displayed or not of using MSPG925
(5) HDCP Key value is different among the sets
6. Adjustment of White Balance
6-1. Purpose and Principle for Adjustment
of the Color Temperature
(1) Purpose: Adjust the color temperature to reduce the
deviation of the module color temperature.
(2) Principle: To adjust the white balance without the
saturation, Fix the one of R/G/B gain to 80 and decrease
the others.
6-2. Adjustment Mode
Two modes of Cool and Warm
(Medium data is automatically calibrated by the cool data)
6-3. Required Equipment
(1) Remote controller for adjustment
(2) Color Analyzer : CA100, CA-100+, CA-210 or same
product
- PLASMA TV(ch : 10)
(3) Auto W/B adjustment instrument(only for Auto adjustment)
6-4. Connecting Diagram of Equipment
for Measuring
(For Automatic Adjustment)
(1) Enter the adjustment mode of the white balance
1) Enter the white balance adjustment mode at the same
time heat-run mode when pushing the power on by
power only key
2) Maintain the white balance adjustment mode with same
condition of Heat-run -> Maintain after AC off/on in
status of Heat-run pattern display
(2) Release the white balance adjustment mode
1) Release the adjust mode after AC off/on or std-by off/on
in status of finishing the Hear-run mode
2) Release the Adjust mode when receiving the aging off
command(F3 00 00) from adjustment equipment
3) Need to transmit the aging off command to TV set after
finishing the adjustment
Copyright©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
ADJUSTMENT INSTRUCTIONS
