LG 26LH1DC3 Installation And Operating Manual Download

Page: 53 / 80

COMMER

CIAL MODE

COMMERCIAL MODE SETUP

*Note1: Disconnect all Aux inputs. Under certain conditions, Auto Program (Channel
search) is disabled if there is an Aux input active.
*Note2: Under certain conditions, changes to the input mode of the RGB
inputs will not take effect until the power is cycled (TV is turned Off and On). To avoid
confusion, disconnect all RGB inputs before entering the Installer menu.

Overview: Commercial Mode Setup Procedure
1. Set Installer Menu Items

(Enter Installer Menu, see page 42 for detailed instructions.)

a. Set Installer menu item

117 FACT DEFAULT

, to

001

and press

ENTER

(This clears all installer menu items, custom settings, channel labels/icons
and reloads the factory default settings.)

b. Set Item 003

BAND/AFC

Broadcast:

set to

000

. -

HRC:

set to

002

CATV:

set to

001

IRC:

set to

003

c. Set item 028 CH OVERIDE to 001. This allows access to Auto Program,

Channel Labels and Channel List options in the Channel Menu.

d. Set other particular installer items that affect your TV programming

network. See pages 57 - 62.

e. After all required installer menu item settings have been adjusted, press

ENTER on the remote to remove Installer Menu.

2. Set Up TV Features

(See Picture, Sound, Setup menus etc. See TV Clonable options list on
page 62.)

*Note: Digital Font options are only available after a channel search has been run
and when the TV is tuned to an active digital channel with digital captions.

3. Run Auto Program

(Search for all available channels.) Go to the Channel menu and access
the Auto Program option, follow on-screen instructions.

a. Edit Channel Scan. In the Channel Menu, access the Channel List menu.
• Delete channels per your system requirements: do you want to delete any

free channels so the guest cannot access them?

• Add familiar Channel Icons like ABC, CBS, NBC etc. to the channel

onscreen display. Add identifiable labels for the end user to readily know
what common networks are available. In the Channel menu, select the
Channel Label option, follow instructions on the bottom of the screen.

4. Transfer TV Setup to Controller Box: 2-5-5 + Menu

After the TV channel scan has been edited and channel label icons added,
enter the Installer menu. Once in the Installer menu, press 2-5-5 and
MENU on the remote. This transfers the TV setup to the internal controller
box.

*Note: Only do 2-5-5 + MENU once or TV setup may be corrupted.
TV scans available channels and exits menu when transfer to controller is complete.

5. Perform Adding Custom Channel Labels: 2-5-4 + Menu Mode

Enter Installer menu, press 2-5-4 and Menu. Add your own custom labels to
the channel on-screen displays. (See page 62.) To remove menu press

*Note: 2-5-4 + MENU can be performed more than once.

Verify TV Setup

At this point, verify that the channel lineup, channel icons and custom
labels are correct. Make sure the TV features are set per your requirements.
Set item

028 CH OVERIDE

000

to lock the channel scan. After the

preceding has been completed, the Master TV setup is ready to be copied to
the LT2002 Clone Programmer, see next page.

This page provides an overview of the TV configuration. See the pages listed below for more specific, detailed
instructions at each step; how to access and use the Installer menu etc.

L26W56XA Installer Menu

L26W56XA Installer Menu Items

RJP (Remote Jack Pack) TV Setup

Custom Channel Label ‘WXYZ’ created in 2-5-4 +

Menu Add Channel Label Mode

After TV setup has been verified,

set item 028 Ch Overide back to 000.

LODGING PTC INSTALLER MENU

117

FACT DEFAULT

00X

003