2
EXTERNAL EQUIPMENT SETUP
EXTERNAL
EQUIPMENT
SETUP
CONNECTING WITH A COMPONENT CABLE
■
To avoid damaging any equipment, never plug in any power cord until you have finished connecting
all equipment.
■
This section on
EXTERNAL EQUIPMENT SETUP
mainly uses diagrams for the 32/37/42/47LD4***
models.
■
Image shown may differ from your TV.
This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do
receive Digital signals from a digital set-top box or other digital external device, refer to the diagram as
shown below.
►
HDMI Audio Supported format : Dolby Digital, PCM
DTS Audio format is not supported.
Component Input ports
To achieve better picture quality, connect a DVD player to the component input ports as shown below.
Signal
Component
HDMI
480i/576i
O
X
480p/576p
O
O
720p/1080i
O
O
1080p
O
(50 Hz / 60 Hz only)
O
(24 Hz / 30 Hz /
50 Hz / 60 Hz)
Component ports on the TV
Y
P
B
P
R
Video output ports
on DVD player
Y
P
B
P
R
Y
B-Y
R-Y
Y
Cb
Cr
Y
Pb
Pr
1
Connect the video outputs (Y, P
B
, P
R
) of the
external equipment (digital set-top box, DVD,
etc.) to the
COMPONENT IN VIDEO
jacks on
the TV.
2
Connect the audio output of the external equip-
ment (digital set-top box, DVD, etc.) to the
COMPONENT IN AUDIO
jacks on the TV.
3
Turn on the external equipment.
(Refer to the external equipment's manual for
operating instructions.)
4
Select the
Component
input source using the
INPUT
button on the remote control.
1
2
1
2
or