9
Note: In some mono models, when the input jacks
on the front panel and back panel are connected to
external equipments at the same time, the input
jacks on the front panel have priority over the
input jacks on the back panel of the TV.
Connecting the S-VHS VCR
(some models)
1. Connect the S-VHS output jack of the VCR to the
S-VIDEO jack on the side or back of TV.
2. Connect the audio/video output jacks of the VCR
to the IN 2(A/V) jacks on the front or side of TV.
3. Press the TV/VIDEO button to select
S-VIDEO
.
4. Press the PLAY button on the VCR.
The video playback is visible on the TV screen.
VCR Recording
(some models)
1. Connect the audio/video input jacks of the
recording VCR to the OUT (A/V) jacks on the back.
2. Select the program number on the TV.
3. Set the recording VCR to record.
Recording a program from con-
necked other equipment
(some models)
1. Connect the output jacks of the playback VCR
to the IN 1(A/V) jacks on the side or back of TV.
2. Connect the input jacks of the recording VCR to
the OUT (A/V) jacks on the back of TV.
3. Press the TV/VIDEO button to select
VIDEO1
or
VIDEO
.
If you connect it to the IN 2 (A/V) jacks on the
side of TV, you should select
VIDEO2
.
4. Press the PLAY button on the playback VCR
and set the recording VCR to record.
Connecting DVD player (some models)
• Connect component DVD inputs to Y, P
B
, P
R
(480i)
and audio IN to audio(L/R) ports.
• Note: This TV is programmed to remember
which mode it was last set to, even if you turn the
TV off.
1.How to connect
2.How to use
• Turn the set on and press the TV/VIDEO button
on the remote control or TV/VIDEO button on the
front panel to select
COMPONENT
.
•Try this after turning on the DVD set.
TV INPUT
Y
P
B
P
R
DV D OUTPUT
Cb
B -Y
Pb
P
B
Cr
R -Y
Pr
P
R
Y
Y
Y
Y
Antenna Connections
Connecting an Outdoor Antenna
For the best reception, we recommend you use an
outdoor antenna.
Severely weathered antennas and antenna cables
can reduce the signal quality. Before connecting it,
necessarily inspect them. Any service center can
explain the various outdoor antennas available to
you.
Note:Rod Antenna Sold Seperately.
300 Ohm Flat Wire
1. Connect the 300 ohm flat wire to screws on the
300 ohm to 75 ohm adapter.
2. Push the end of 300 ohm to 75 ohm adapter
into 75 ohm antenna jack.
75 Ohm Coaxial Cable
1. Connect the 75 ohm coaxial cable directly to
the antenna jack.
Connecting a CATV Cable
If you subscribe to a CATV system, change the
antenna connection as described below.
1. Remove the 300 to 75 ohm adapter or the
cable from the set if attached.
2. Connect the CATV cable (75 ohm coaxial
cable) to the 75 ohm antenna jack.
