20
INSTALLATION
Connecting to the Power
Supply
The washer should be plugged into a 120-VAC, 60
Hz grounded 3-prong outlet. Plug in the washer.
WARNING
•
Do not use a worn or damaged power cord or
power plug. Replace or repair it immediately.
Failure to do so may result in death, fire, electric
shock, or malfunction.
•
Do not modify the power cord and plug
provided with the appliance. Do not damage
it when installing or moving the washer. Doing
so may result in death, fire, electric shock, or
malfunction.
•
Make sure that the washer is grounded.
•
Connect this washer to a grounded outlet
conforming to the rating prior to use. Failure
to do so may result in fire, electric shock, or
malfunction.
•
Do not damage or cut off the ground prong of
the power cord. Doing so may cause death, fire,
electric shock, or product malfunction.
•
Improper connection of the equipment-grounding
conductor can result in risk of electric shock.
Check with a qualified electrician or service
technician if you are in doubt as to whether the
appliance is properly grounded. If it does not fit
the outlet, have a proper outlet installed by a
qualified electrician.
•
The appliance and outlet must be positioned so
that the plug is easily accessible.
•
Do not use adapters or extension cords. Doing
so may result in serious injury, fire, electric
shock, or death.
•
For best performance, plug the washer into
its own individual outlet. This helps prevent
overloading house wiring circuits which could
cause a fire hazard from overheated wires.
•
If necessary, use a new, UL-listed 3-prong
adapter or 3-wire extension cord with a 3-prong
(grounding) plug rated at no less than the branch
circuit. Do not use an extension cord longer
than 3 feet. Failure to follow these warnings may
result in serious injury, fire, electric shock, or
death.
Testing the Washer
Check if the washer is properly installed and run a
test cycle.
1
Load the washer with 2 pounds of laundry
(approximately 2 thick bath towels).
2
Press the
Power
button.
3
Select the
Rinse+Spin
.
4
Press the
Start/Pause
button.
The wash cycle starts.
5
Check if water is supplied, that the machine does
not rock or vibrate excessively, and that it drains
well during the spin cycle.
NOTE
•
If water leaks during water supply, see Connecting
the Water Lines to connect them properly.
•
If the washer rocks and vibrates excessively, see
Leveling the Appliance to level it again.
•
If the drain does not work, see Connecting the Drain
Hose to install the hose properly.
