LG SIGNATURE LSWD100E, Owner'S Manual

Page: 55 / 64

55
TROUBLESHOOTING
ENGLISH
TROUBLESHOOTING
Operation of your appliance can lead to errors and malfunctions. The following tables contain possible
causes and notes for resolving an error message or malfunction. It is recommended to read the tables
carefully below in order to save your time and money that may cost for calling to LG Electronics service
centre.
Before Calling for Service
Your appliance is equipped with an automatic error-monitoring system to detect and diagnose problems
at an early stage. If the appliance does not function properly or does not function at all, check the following
tables before calling to LG Electronics service centre.
Error Messages
Symptoms Possible Cause & Solution
[IE]
INLET ERROR Water supply faucets are not fully open.
• Make sure that the water faucets are fully open.
Water inlet hoses are kinked, pinched, or crushed.
• Make sure that the hoses are not kinked, pinched or crushed behind or
under the washer. Be careful when moving the washer during cleaning or
maintenance.
Water inlet filters are clogged.
• Clean the inlet filters. See MAINTENANCE .
Water supply pressure to faucet or house is too low.
• Check another faucet in the house to make sure that household water
pressure is adequate and flow is not restricted.
• Disconnect the water inlet hoses from the washer and run a few gallons of
water through the hoses to flush out any dirt.
• If flow is too low, contact a plumber to have the water supply lines
repaired.
Water supply connected with leak-limiting hoses.
• The use of hoses designed to limit leaks is not recommended. Leak limiting
hoses can trip falsely and prevent the washer from filling.