INITIAL INSTALLATION
8
Remove pin (L) and clip (M) from downrod (A).
Partially loosen preassembled set screws and nuts
in yoke at top of motor housing (D).
5.
5A
M
L
5B
A
Set Screw
Sideview
D
Yoke
6. Insert downrod (A) through canopy (B), canopy
cover (H) and yoke cover (E).
NOTE:
Canopy
cover (H) must be turned with the shiny side
toward
the motor housing (D).
Then, thread wires from motor housing (D)
through downrod (A).
6
B
E
A
H
7. Slip downrod (A) into motor housing yoke, align
holes and re-install pin (L) and clip (M). Tighten
set screws in motor housing yoke and then tighten
preassembled nuts on the set screws. Then, slide
yoke cover (E) down until it rests on top of motor
housing (D).
7
A
D
E
L
M
Yoke
M
L
Set Screw
and Nut
Sideview
