Lexus RCF 2022, Owner'S Manual

Page: 196 / 412

194
4-5. Using the driving support systems
RC F Owner's Manual
The control standby state will be entered
and the engine speed will be automatically
maintained between 1500-2000 rpm.
If the “LAUNCH” indicator turns off,
release the accelerator pedal and perform
this procedure again from
6
.
8 Within 3 seconds of depressing the
accelerator pedal, release the
brake pedal to start off.
The “LAUNCH” indicator will turn off 3
seconds after the accelerator pedal is
depressed.
If the brake pedal is not released before the
“LAUNCH” indicator turns off, release the
accelerator pedal and perform this proce-
dure again from
6
.
After starting off, when the accelerator
pedal is released, launch control will stop
operating.
■
Canceling launch control
Perform any of the following:
 Shift the shift lever to any position
other than D.

Operate the drive mode switch to
select any mode other than SPORT
S+ mode.

Press the switch.
 Press the “LAUNCH” switch.
■
Operation condition
When all of the following conditions are
met, launch control can be enabled:
● The engine and transmission are suffi-
ciently warmed up.
● The engine, transmission, driving support
systems, etc. are not malfunctioning.
■ Launch control will not operate prop-
erly when
In the following situations, launch control
may not operate properly:
● When the brake pedal is not firmly
depressed and the rear wheels slip.
● When starting off on a road surface that
is wet with rain, standing water, etc.
● When starting off on a slick road surface.
● When the vehicle has not been properly
maintained (tires are worn out, tire pres-
sure is low, etc.).
WARNING
■ Launch control precautions
Observe the following precautions.
Failure to do so may result in death or
serious injury.
● Do not use on public roads.
● Use only when road and ambient con-
ditions are safe.
● Before use, ensure that no people or
obstructions are nearby.
● Proper use of launch control requires
an expert level of driving skill. When
using launch control, always check the
track conditions and surrounding area.
● Do not start off with the rear wheels
spinning.
NOTICE
■ To avoid damage to the vehicle when
using launch control
● As launch control applies a large load
on vehicle components, do not use it
excessively.
● Always follow the correct operation
procedures as described in this man-
ual.
● Only use launch control on dry, paved
roads, as slippery or loose road sur-
faces may cause damage to the vehi-
cle.
● When using launch control repeatedly,
wait approximately 10 minutes
between each use.