89
■
Programming the HomeLink
®
Press and release the HomeLink
®
button you want to program and check that the
HomeLink
®
indicator light flashes orange.
Perform
within 60 seconds of
,
or the indicator light will stop flashing and pro-
gramming will not be able to be completed.
Point the remote control transmitter for
the device at the rear view mirror, 1 to 3
in. (25 to 75 mm) from the Home-
Link
®
buttons.
Keep the HomeLink
®
indicator light
in view while programming.
For U.S.A. owners
Press and hold the remote control
transmitter button until the Home-
Link
®
indicator light changes from
slowly flashing orange to rapidly flash-
ing green (rolling code) or continu-
ously lit green (fixed code), then
release the button.
Programming an entry gate (for U.S.A. owners)/Programming a device in the Cana-
dian market
Press and release the remote control transmitter button at 2 second intervals, repeat-
edly, until the HomeLink
®
indicator light changes from slowly flashing orange to rapidly
flashing green (rolling code) or continuously lit green (fixed code).
Test the HomeLink
®
operation by pressing the newly programmed button and observ-
ing the indicator light:
●
Device with fixed code: If the indicator light is solid/continuous, programming has
been completed and your garage door or other device should operate when the
HomeLink
®
button is pressed and released.
●
Device with rolling code: If the indicator light flashes rapidly, your garage door
opener motor (or other device) is equipped with a rolling code. Complete the pro-
gramming process by firmly pressing and holding the programmed HomeLink
®
button for 2 seconds and then release the button.
●
If the garage door or other device does not operate, proceed to “Programming a
rolling code system”.
1
3
1
2
3
3
4
Summary of Contents for NX 200t 2016
Page 105: ...105 Memo...
