Lexus LS 460 2017, Manual

Page: 161 / 708

161
3-2. Opening, closing and locking the doors
3
O
per
at
io
n o
f ea
ch
co
m
po
nen
t
LS460/LS460L_GE (OM50G06E)
■
Switching the door unlock function
It is possible to set which doors the entry function unlocks using the wireless remote
control.
Turn the engine switch off.
Cancel the intrusion sensor and tilt sensor of the alarm system to prevent unin-
tended triggering of the alarm during the setting change. (if equipped) (

P. 115)
Press and hold , or for approximately 5 seconds while pressing
and holding .
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds,
and repeat step
.)
To prevent unintended triggering of the alarm, unlock the doors using the wireless
remote control and open and close a door once after the settings have been
changed. (If a door is not opened within 30 seconds after
is pressed, the
doors will be locked again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (

P. 113)
1
2
3
3
Multi-information
display
Unlocking function Beep
Hold a door handle to unlock
all doors Exterior: Beeps twice
Interior: Rings once
Hold the driver’s door handle
to unlock only the driver’s door Exterior: Beeps 3 times
Interior: Rings once
Hold a passenger’s door han-
dle to unlock all the doors
Hold the door handle to
unlock the front and rear doors
on your side
Exterior: Beeps 4 times
Interior: Rings once
Hold the door handle to
unlock the door Exterior: Beeps once
Interior: Rings once