Lexmark XM9100 Series, User Manual

Page: 131 / 364

Use To
Print Setup Page Print a report containing information about the network printer settings, such as the TCP/IP address.
Network Card menu
To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > Network Card
•
Network/Ports > Network [x] > Network [x] Setup > Network Card
Use To
View Card Status
Connected
Disconnected
View the connection status of the wireless network adapter.
View Card Speed View the speed of an active wireless network adapter.
Network Address
UAA
LAA
View the network addresses.
Job Timeout
0, 10–225 seconds
Set the amount of time it takes for a network print job to be canceled.
Notes:
•
“90 seconds” is the factory default setting.
• A setting value of 0 disables the timeout.
•
If a value between 1 and 9 is selected, then
Invalid
appears on the
display, and the value is not saved.
Banner Page
Off
On
Allow the printer to print a banner page.
Note: Off is the factory default setting.
TCP/IP menu
To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > TCP/IP
•
Network/Ports > Network [x] > Network [x] Setup > TCP/IP
Note: This menu is available only in network printers or printers attached to print servers.
Use To
Set Hostname Set the current TCP/IP host name.
Note: This can be changed only from the Embedded Web Server.
IP Address View or change the current TCP/IP address.
Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IP
settings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems that
support BOOTP and RARP.
Netmask View or change the current TCP/IP netmask.
Understanding the printer menus 131