62
MarkNet print server setup
Print a network setup page
During setup, you connected your printer to a network and assigned an IP
address. Verify that the correct TCP/IP and DHCP information is displayed on
the network setup page.
Use the printer operator panel to print the network setup page. (Hint: Network
Menu/Network Option x/Network x Setup/Print/Print Setup Page) This page shows
the physical address of the MarkNet print server (UAA) and other important
data. Save this page because you will use it later.
For more information about
using the printer operator
panel, refer to your printer
documentation.
❏
If the IP address, netmask, and gateway are correct on the MarkNet
print server network setup page, skip to “Set up to print” on page 65.
❏
If the TCP/IP information on the setup page is not correct, go to the next
step and find the complete set of instructions for TCP/IP.
❏
To connect the printer to a network other than TCP/IP, go on to the next
step and find the configuration for your appropriate network.
Configure and print
1
Network environment
Page
TCP/IP
Novell NetWare
AppleTalk
OS/2 Warp Server
2
