11
Scan unit SCSI ID and termination settings
If you purchased an
OptraImage 514/524, refer to
the documents that shipped
with your scan unit for
information about default
switch and termination
settings.
If you purchased an OptraImage 212/222, 312/322, Color 1200r, Color 1200p,
T612s, or T612p
, make sure the SCSI ID is set to 6 and the termination switch is
pushed all the way to the right.
If you purchased an OptraImage 715/725, W810s, or W810p
, make sure the
terminator is still installed on one the SCSI ports of the scan unit.
Choose a location for the control panel
Before assembling the system and connecting the cables, choose a good location
for the control panel. Normally, a location near the scan unit works best.
The following illustration is the recommended OptraImage setup.
Termination
switch
SCSI ID
(default is 6)
Terminator
4
