Lexmark Forms Printer 2580, Technical Reference

Page: 8 / 120

SIC Command
1-2
Draft document
SIC Command Format
Usage Notes:
•
"n1 is the low order byte. n2 is the high order byte. n1 and n2 specify the
number of mode bytes in the escape sequence. n1 is the number of
para2. (the number of parameters plus init and id.) Normally, n1 is 1,
3 or 4. n2 is always 0.
•
"init - this parameter specifies which condition the printer should be initialized
to. See the Initial Values table below for details.
•
"id - This parameter specifies the parm conditions that follow it. See the Id
Values table below for details.
Init Values
“init” sets the printer to user-defined or factory settings. The following table describes
the valid init values and their affect on the printer default settings initialization, macro
settings and download font:
Format: ESC [ K n1 n2 init id parm1 parm 2... parm 24
Decimal: 27 91 75 n1 0 init id parm1 parm 2... parm 24
Hexadecimal: 1B 5B 4B n1 00 init id parm1 parm 2... parm 24
Table 1-1: Initial Values
Dec Hex Current Settings
User Default
Settings Default Macro
Settings Other Macro
Settings Download
Font
0 00 Initialized to the user default
setting.
Then updated to updated to
reflect parm values in SIC
command
unchanged Initialized to the
user default
settings. Not initialized. Not cleared.
1 01 Initialized to the user default
setting.
Then updated to updated to
reflect parm values in SIC
command
unchanged Initialized to the
user default
settings. Not initialized Cleared.