CAUTION—POTENTIAL INJURY:
When moving the printer, follow these guidelines to avoid personal
injury or printer damage:
•
Make sure that all doors and trays are closed.
•
Turn off the printer, and then unplug the power cord from the electrical outlet.
•
Disconnect all cords and cables from the printer.
•
If the printer has separate floor-standing optional trays or output options attached to it, then disconnect
them before moving the printer.
•
If the printer has a caster base, then carefully roll it to the new location. Use caution when passing over
thresholds and breaks in flooring.
•
If the printer does not have a caster base but is configured with optional trays or output options, then remove
the output options and lift the printer off the trays. Do not try to lift the printer and any options at the same
time.
•
Always use the handholds on the printer to lift it.
•
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
•
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
•
Keep the printer in an upright position.
•
Avoid severe jarring movements.
•
Make sure that your fingers are not under the printer when you set it down.
•
Make sure that there is adequate clearance around the printer.
Note:
Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to
Saving energy and paper
Setting up power saver modes
Eco
‑
Mode
1
From the home screen, touch
Settings
>
Device
>
Power Management
>
Eco
‑
Mode
.
2
Select a setting.
Sleep mode
1
From the home screen, touch
Settings
>
Device
>
Power Management
>
Timeouts
>
Sleep Mode
.
2
Enter the number of minutes the printer stays idle before it enters Sleep mode.
Hibernate mode
1
From the home screen, touch
Settings
>
Device
>
Power Management
>
Timeouts
>
Hibernate Timeout
.
2
Select the amount of time before the printer enters hibernate mode.
Maintaining the printer
65
Summary of Contents for CS820 Series
Page 1: ...CS820 CS827 User s Guide October 2017 www lexmark com Machine type s 5063 Model s 530 571...
Page 74: ...2 Remove the jammed paper Note Make sure that all paper fragments are removed Clearing jams 74...
Page 80: ...4 Close the staple guard 5 Insert the staple cartridge holder 6 Close door G Clearing jams 80...