6
Change the address by pressing Menu to increase or decrease
each number. Press Select to move to the next segment. Press
Select when you are finished.
The message
Saved
appears briefly.
7
Press Menu until you see
Set IP Netmask
, and then press
Select.
8
Repeat step 6 to set the IP Netmask.
9
Press Menu until you see
Set IP Gateway
, and then press
Select.
10
Repeat step 6 to set the IP Gateway.
11
When you are finished, press Go to return the printer to the
Ready
state.
Verifying the IP
1
Print another network setup page. Look under the “TCP/IP”
settings
heading and make sure the IP address, netmask, and gateway
are what you expected. See “Printing a network setup page” on
page 64 if you need help.
Note:
On Windows
2
Ping the printer and verify that it responds. For example, at a
computers, click Start
command prompt on a network computer, type “ping” followed
Programs
Command
by the new printer IP address (for example, 192.168.0.11):
prompt (or Accessories
Command prompt if using
ping 192.168.0.11
Windows 2000).
If the printer is active on the network, you receive a reply.
Configuring for
If your printer has an optional Lexmark ImageQuick™ firmware card
Pull Printing
installed, you can configure for Pull Printing once an IP address is
assigned to the printer.
For detailed configuration instructions, refer to the CD that shipped
with the Lexmark ImageQuick card.
Configure for TCP/IP
67