Page 12 of 17
© Copyright 2006 Lexmark International Inc.
This document may be freely reproduced and distributed whole and intact including this Copyright Notice.
O
PERATION IN FIPS MODE
The PrintCryption meets Level 1 requirements for FIPS 140-2. The sections
below describe how to place and keep the module in FIPS-approved mode of
operation.
Initial Setup
The DLE card containing PrintCryption module may be factory installed or user-
installed. Lexmark provides an Installation sheet, a driver CD with publications,
and license agreement for the module in the option kit.
Installation procedure of the module is as follows.
1.
Print a menu settings page from an AIO:
a.
Press
Menu
and then select Reports.
b.
Press
Menu
Settings Page
to print the page.
Note: This Page is needed for later use.
c.
Configure the printer onto the TCP/IP network per installation
requirements. If the printer is behind a firewall, it must allow IP
ports 9150 and 9152 to pass through.
1.
Print a menu settings page from a printer:
a.
Press
Menus
until
Utilities
menu appears, and then press
Select
.
b.
Press
Menu
until Print menu appears, and then press
Select
to
print the page.
Note: This Page is needed for later use.
c.
Configure the printer onto the TCP/IP network per installation
requirements. If the printer is behind a firewall, it must allow IP
ports 9150 and 9152 to pass through.
2.
Turn off the printer and install the card. Please refer to the printer’s
documentation for further instructions on installing the card.
3.
Turn the printer on.
a.
If the printer displays the message
41 – Unsupported Firmware
Card
, then the installed card is not compatible for the printer. Turn
off the printer and remove the card.