Rev. 9-2011
L E X I U M
D B S 7 0 0 0
DIGITAL FREE TO AIR SATELLITE
RECEIVER
INSTALLATION MANUAL
This manual will provide you with step by step instructions on how
to setup your satellite receiver, program the receiver, and start
watching TV.
IMPORTANT NOTICE:
When installing your new satellite receiver,
make sure that the receiver is
NOT
plugged into the power outlet
before you start attaching and/or detaching the cables & wires
coming into your receiver from the satellite dish, and going to
your TV from the receiver. Once you have all the wires and cables
connected to your receiver, you can then plug the receiver in.
Failure to follow this step may damage your LNBF on your satellite
dish, and/or damage your new receiver. Such damage is due to
negligence, and therefore it's not covered under your warranty.
To start out, first connect the cable coming in from your satellite
dish to the “LNB IN” port on the back of the receiver. Connect the
receiver to your TV using the RF OUT port of the receiver with RG6
or RG59 cable (Not supplied) or the supplied HDMI cable using the
HDMI ouput port, or RCA cables using the Audio/Video port.
IMPORTANT:
The only cable approved to connect your satellite dish
to your receiver is RG6 coaxial cable. When putting the connectors
on the cable going from the satellite dish to your receiver, be
sure that the wires around the center conductor (center wire) is
not touching or making any kind of connections to the center
conductor. If the small strands of wires, even if one is touching
the center conductor, it will short out the wire and will cause
your receiver and/or your LNBF to burn and your satellite system
will not work properly. Any damage caused to your equipment due to
this will not be covered under warranty.
