READ THE
FULL MANUAL
!
LEARN EVERYTHING ABOUT YOUR LCT 640 TS
www.lewitt-audio.com/resources/manuals/LCT-640-TS.pdf
//
LCT 640 TS
QUICKSTART GUIDE
//
Polarizer
Plugin
Check out our plugin! You can seamlessly change the
polar pattern right in your favourite audio workstation -
even after the recording session. It works on PC and MAC
likewise. The following plug in standards are supported:
VST, AU and AAX
Download the Polarizer - Change and fine-tune the pattern
of your LCT 640 TS right in your DAW!
www.lewitt-audio.com/downloads/LCT-640-TS
//
Set patterns manually
It is also possible to generate the polar patterns manually, without the plugin. The following chart will tell you how to do it and also
give you some useful information about polar patterns.
Parameter
Omni
Broad cardioid
Cardioid
Super cardioid
Figure-8
Front Diaphragm
Level
0 dB
0 dB
0 dB
0 dB
0 dB
Back Diaphragm
Level
0 dB
-10 dB
-
∞
dB
-10 dB
0 dB
Front Diaphragm
Phase
0°
0°
0°
0°
0°
Back Diaphragm
Phase
0°
0°
0°
180°
180°
Acceptance angle
(-3 dB reduction)
-
90°
65°
57°
45°
Maximum
reduction
-
180°
180°
126°
90°
Distance
Factor
*
1
1,38
1,73
1,93
1,73
//
Attention
It takes up to 20 seconds after phantom power is applied till the microphone reaches it’s full sensitivity!
It takes up to 20 seconds till the switch between polar patterns is complete!
Always apply phantom power to output A for normal operation
Always apply phantom power to outputs A and B in Dual Output Mode.
* Distance the microphone can be placed further away from the source compared to the omni characteristic while preserving the ratio of direct and diffuse sound.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
