6.1.5 Change of Coupling - toothed rim
Also refer to the attached, separate operating instruction B 1.950).
1. Switch off metering pump.
Safeguard drive element against unintentional operation (disconnect power
supply, also refer to section 1.4 “Safety” in operating instruction B 0.100.1 for
this).
2.
Remove 4 hexagon head screws at the motor flange and lift-off motor.
3. Remove toothed rim and replace by a new toothed rim.
4.
Mount motor again and tighten using the 4 hexagon head screws.
6.2 Repairs
6.2.1 Standard tools:
allen keys:
size 4/5 mm,
open ended spanner: size 10/ 13/ 19 mm,
plastic hammer, screw drivers (different sizes), circlip pliers (inside and outside), soft metal drifts,
claw pulling device, pulling device with sliding hammer (insert for M8).
6.2.2 Required documents
Additional documents required: sectional drawing “Metering pump type LCA” and relevant parts list.
6.2.3 Wear parts
Please check whether the parts marked "V" in parts list are available.
For machines having an operating time of > 5 years we recommend to have the parts designated ”E”
available also.
For safety reasons, parts designated “E” or “V” in the parts list should be re-used as an exception and
after thorough inspection only.
6.3 Dismantling / Assembly
Refer to sectional drawing / parts list of drive element.
6.3.1 Preparation Dismantling/ Assembly
Reserve suitable clean area for depositing the individual parts.
Safeguard drive element against unintentional operation (disconnect power supply,
also refer to section “1.4 Safety” in operating instruction B 0 100.1 for this).
Take drive element to a dry, enclosed, but well ventilated and essentially dust-free room for
dismantling / assembly if possible.
•
Clean all parts to be used again thoroughly, however, if possible, do so only just before
re-assembly.
Use a cold cleaner to remove lubricant residues.
Observe any safety and disposal instructions!
•
Check
all parts for perfect condition before installation.
•
Slip agents, lubricants
a) Radial seal rings and O-rings must be thinly coated with the lubricating agent specified for
operation before assembly.
b) Screws and threaded shafts must be coated with the lubricating agent specified for operation
before assembly.
7
Drive element LEWA - ecosmart® type LCA manual stroke adjust., motor vertically B 1.660 en
