7
GETTING STARTED
1.
Open the back cover of the air purifier
and remove both filters from their plastic
packaging.
[Figure 1.1]
2.
First, place the Activated Carbon Filter
back into the air purifier. Then, place
the Preliminary/True HEPA Combination
Filter. Make sure the pull tabs on both
filters are facing out.
[Figure 1.2]
3.
Replace the back cover by lining up the
cover’s feet with the matching slots on
the bottom of the housing. Make sure
that the triangular piece at the bottom of
the cover is touching the safety switch.
[Figure 1.3]
4.
Push the cover closed.
5.
Place the air purifier on a hard,
flat surface. Leave 38 cm / 15 in of
clearance on all sides of the air purifier.
[Figure 1.4]
Note:
Do not
remove the foam
piece attached to the dust sensor
cover unless instructed by
Customer
Support
.
[Figure 1.5]
Figure 1.1
Figure 1.4
Figure 1.5
Figure 1.2
Figure 1.3
Tabs facing
outward
38 cm /
15 in
Safety
switch
38 cm /
15 in