Page 5 of 6
PK-93776-10-02-0B
Opt-X
®
500i FIBER RING
(Removal, Installation and Assembly)
Opt-X
®
Fiber management ¼ rings are pre-installed at the factory. To remove, grip the ¼ ring, lift the Position-
Locking Tab, turn counter clockwise until unlocked, and then lift to remove. When removing a half or full
management ring group, simultaneously lift the 2 or 4 Position-Locking Tabs, turn counter clockwise until unlocked,
and then lift to remove.
RING STACKING
Position initial ring unit (¼, ½, or full) upside
down on a flat surface. Position additional
ring upside down above initial ring and
press together using sufficient force to
engage stack locking device.
CAUTION – always perform stacking
before installing ring unit into tray.
HALF RING ASSEMBLY
Hold a ¼ ring unit in each hand, bring the units
together and engage by placing the tab of the left
unit into the slot of the right unit.
HALF RING INSTALLATION Position ½ ring unit
over outer ring slots so the alignment tabs fit into
slots. Press down and turn the ½ ring unit clock-
wise to engage tabs and lock into position.
CAUTION
– when installing into a tray that is in the
enclosure, provide adequate support under the tray
by placing a hand under the ring slot area.
FULL RING ASSEMBLY
Hold a ½ ring unit in each hand, bring units together
with tabs above slots, rotate to engage tabs.
FULL RING INSTALLATION Position full ring unit
over inner and outer ring slots so alignment tabs fit
into slots. Firmly press down and turn the full ring
unit clockwise to engage tabs and lock into position.
CAUTION – when installing into a tray that is in the
enclosure, provide adequate support under the tray
by placing a hand under the ring slot area.
HALF RING ASSEMBLY
FULL RING ASSEMBLY
RING STACKING
Tab
Stacking/Locking
Device (Upper)
Stacking/Locking
Device (Lower)
Slot
RING OVERVIEW
RING SIDE PROFILE
RING ALIGNMENT SLOTS
Position-Locking Tab
Turn
Push
