Configuration
Configuration Data - Quick Setup Screen
Router
Device (Host) Name
Normally, there is no need to change the default name, but if
your ISP requests that you use a particular "Hostname", enter
it here. This name will be provided to, and recorded by, the
remote DHCP Server.
Hardware (MAC)
Address
Also called
Network Adapter Address
or
Physical Address
.
This is a low-level identifier for the LevelOne WBR-1101TX,
as seen from the WAN port.
Provide this value to your ISP if requested. If you did not
provide this value when first connected, there is no need to
provide it now.
LAN
Device IP Address
IP address for the LevelOne WBR-1101TX, as seen from the
local LAN. Use the default value of 192.168.0.1 unless the
address is already in use or your LAN is using a different IP
address range. In the latter case, enter an unused IP Address
from within the range used by your LAN.
Network Mask
The default value 255.255.255.0 is standard for small (class
"C") networks. For other networks, use the Network Mask for
the LAN segment to which the LevelOne WBR-1101TX is
attached. i.e. the same value as the PCs on that LAN segment.
DHCP Server
See Chapter 5 for further details about DHCP.
•
If
Enabled
, the LevelOne WBR-1101TX will allocate IP
Addresses to PCs on your LAN. The default and recom-
mended value is
Enabled
.
•
If you are already using a DHCP Server, this setting must
be DISABLED, and the existing DHCP server must be
re-configured as described in
Chapter 5 - DHCP
.
•
The
Start IP Address
and
Finish IP Address fields
set
the values used by the DHCP server when allocating IP
Addresses to DHCP clients.
This range also determines the number of DHCP clients
supported. (Maximum is 253.)
15