communicate each other, but they can access the internet and other Ethernet LAN
devices
9. AP Isolation:
If you enabled multiple VAPs in this device, you can further decide
whether the wireless clients associated to different VAPs can access to each other
or not. When you enabled the AP Isolation function, Each VAP is isolated to the
others consequently.
10. TX Rate:
For WiFi transmit rate, you can choose “Best” for auto-adjustment
according to WiFi signal quality in your environment, or you can fix it in certain TX
rate. Please note the WiFi connection may be dropped if you fix at a higher date
rate but in a noisy (poor RF signal quality) environment.
Afterwards,
click on “Save” to store your settings or click “Undo” to give up the
changes.
3.1.2.2.2 Advanced RF Module2 Settings
1. Regulatory Domain:
The availability of some specific channels and/or
operational frequency bands is country dependent.
2. Beacon interval
: Beacons are packets sent by a wireless router to synchronize
wireless devices.
3. Transmit Power
: Normally the wireless transmission power operates at 100% out
power specification of this device. You can lower down the power ratio to prevent
transmissions from reaching beyond your corporate/home office or designated
wireless area.
4. RTS Threshold:
If an excessive number of wireless packet collision occurred, the
wireless performance will be affected. It can be improved by adjusting the
RTS/CTS (Request to Send/Clear to Send) threshold value.
