Desktop Installation
Set the Switch on a sufficiently large flat space with a power outlet nearby. The
surface where you put your Switch should be clean, smooth, level and sturdy.
Make sure there is enough clearance around the Switch to allow attachment of
cables, power cord and allow air circulation.
Attaching Rubber Feet
1. Make sure mounting surface on the bottom of the Switch is grease and
dust free.
2. Remove adhesive backing from your Rubber Feet.
3. Apply the Rubber Feet to each corner on the bottom of the Switch. These
footpads can prevent the Switch from shock/vibration.
Rack-mounted Installation
The 24 10/100BASE-TX + 100Base-FX slot Web smart Switch comes with a
rack-mounted kit and can be mounted in an EIA standard size, 19-inch Rack.
The Switch can be placed in a wiring closet with other equipment. Perform the
following steps to rack mount the switch:
1. Position one bracket to align with the holes on one side of the switch and
secure it with the smaller bracket screws. Then attach the remaining
bracket to the other side of the Switch.
2. After attached mounting brackets, position the Switch in the rack by lining
up the holes in the brackets with the appropriate holes on the rack. Secure
the Switch to the rack with a screwdriver and the rack-mounting screws.
Note:
For proper ventilation, allow about at least 4 inches (10 cm) of
clearance on the front and 3.4 inches (8 cm) on the back of the Switch.
This is especially important for enclosed rack installation.
6
Summary of Contents for FSW-2470
Page 2: ......
Page 24: ...Change Password Interface 20 ...