LevelOne Broadband Router User Guide
FBR-1402TX / FBR-1403TX Rear Panel
Figure 4: FBR-1402TX / FBR-1403TX Rear Panel
Printer Port
(FBR-1403TX only)
Standard parallel printer port. If you wish to share a printer,
connect it here.
Reset Button
This button has three (3) functions:
•
Reboot
. When pressed and released, the LevelOne Broad-
band Router will reboot (restart).
•
Diagnostic print-out
. If held down for 3 seconds, a diag-
nostic print-out will be sent to the attached printer.
•
Ensure the printer is ready.
•
Both
LEDs will flash simultaneously during the
diagnostic printing.
•
Clear All Data
. This button can also be used to clear ALL
data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power
Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the
RED LED has flashed TWICE.
4. Release the Reset Button. The LevelOne Broadband Router
is now using the factory default values.
WAN port
(10/100BaseT)
Connect the DSL or Cable Modem here. If your modem came
with a cable, use the supplied cable. Otherwise, use a standard
LAN cable.
10/100BaseT
LAN connections
Use standard LAN cables (RJ45 connectors) to connect your PCs
to these ports.
Uplink Button
This button allows LAN port 1 to be used as an Uplink port for
connecting directly to another hub.
•
When depressed (in), then the "LAN 1" port becomes an
"Uplink" port, and must be connected to a normal port on
another Hub.
•
If this button is extended (out), then the "LAN 1" port acts as
a normal LAN port.
Power input
Connect the supplied power adapter here.
6