9
Installation and Operation
AVE-93XX supports different video format by using different cable kit. Section 1 will
describe how to extend
VGA and Audio signals
by PC cable kit and in Section 2&3, you
should find the description of how to use
HDTV(YCC-9007, YCC-9018)
and
TV(RCA-9007,
RCA-9018)
cable kit:
Section 1: Extend VGA Video and Audio by PC Cable Kit
1.
AVE-9301 Single-Port Transmitter Installation:
(1)
Connecting Monitor and Speaker:
Take VGA-0010 cable to connect the signal from
your A/V device to the “VGA+AUDIO IN” port of Transmitter box and then connect
monitor and speaker to the “VGA OUT” and “AUDIO” ports. Please refer to
Fig.
VGA-0010.
(2)
Function Test:
Turn on your A/V device, the POWER LED should turn on green to
indicate the POWER ON status and the LEDs above RJ-45 will blink before VGA signal is
turned ON and remain ON after VGA signal is turned ON.
2.
Receiver AVE-9300 installation and UTP Connection:
(1)
Power Up:
Plug power adapter to the Receiver and connect monitor and speaker to the
“VGA OUT” and “AUDIO” port. The POWER LED will turn on green to indicate the
POWER ON status and the LED above RJ-45 port should blink to indicate the A/V signal
unconnected status.
(2)
Selection of UTP Cable:
For best VGA resolution, please use Cat5 Enhanced cable
(350MHz bandwidth) for connection, please noted that the maximum extended length of
one section (one pair of Transmitter or Receiver) should not exceed 300 meters. The
connector must be made by 568B/568B type.
(3)
Connect UTP Cable:
Plug two ends of UTP cable to Transmitter and Receiver’s RJ45
SYSTEM LINK ports, the Receiver’s connected monitor and speaker should work now and
the LEDs above RJ-45 port should remain ON. You can adjust the “FOCUS” and “GAIN”
control of Receiver to have the best VGA display.
(4)
Function Test:
After above installation, you will be able to broadcast the A/V signal to
JACK POSITION
PAIR 2
PAIR 3
PAIR 1
PAIR 4
