levante-products.com
Change of filter (especially to suit this model, to be purchased separately)
1. Take off the shell, and remove the filter cover at the base as directed by the arrow mark in the diagram.
2. Place the filter into the filter housing and replace back cover.
APPLICATION
1. After installation is completed, connect the device to power and it will be stand-by-mode.
2. When you hands reaches within 10cm to the nozzle, the hand dryer will automatically sense it and start to blow warm
air. Follow the instructions as showed in Figures 6, 7, and 8 till your hands are dry. It will stop operation after 1 second
after you hands move away. If the hand dryer continues to operate for 1 minute, the air flow will stop; it may be restarted
when the sensing process is activated again.
3. In order to be operational in various working environments, the infrared transmitter has been set to the highest degree of
sensitivity. In the event of prolonged operation or not working, please make adjustment in accordance with Fig. 9.
4. There is an built-in heating element switch; if you want to shift between cold and warm air, take off the shell (Fig. 2), and
operate the switch (as showed in Fig. 9) to make the shift (the default setting is warm air).
10. Heating element switch
11. Resistor with variable
sensitivity
(Fine tune)
fig. 6
fig. 8
fig. 7
fig. 9
10
11
Summary of Contents for TEMPESTA
Page 8: ...levante products com NOTES...
Page 9: ...levante products com...
