If using the included rechargeable battery:
If the signal appears poor, it
Note: The battery does not need to be inserted to operate the monitor from a wall outlet. However,
keeping the battery in the unit will ensure that it is charged when you need to unplug it from the wall.
1. Plug one end of the provided power adapter into a wall outlet (both camera
and monitor power adapters are interchangeable).
2. Connect the other end of the power adapter into the power input on
the monitor.
3. Turn on the monitor by turning the volume knob on the side of the unit. You
will feel a slight click when it turns on.
4. When the monitor is on, the POWER LED on the monitor will light up GREEN.
5. It takes approximately 3 hours to fully charge your monitor battery.
Adjusting Monitor Brightness
1. If the image on the LCD screen is too light, press the
button (lower button) to darken
the screen.
2. If the image on the LCD screen is too dark, press the
button (higher button) to lighten
the screen.
Sound Activation (VOX)
The BABYVIEW20 system lets you turn off the monitor while you are sleeping, and will automatically turn back
on if your child starts to cry or make noise.
1. Press the “VOX” button on the left side of the monitor. This will turn off the screen but the “VOX” LED on
the front of the monitor will glow blue.
2. When the sound from the camera reaches the set level, the screen will turn on automatically. It will turn
off again after 30 seconds.
NOTE: the preset noise level is preset to a level comparable to a casual conversation.
7
MONITOR SETUP
BABYVIEW_Manual.indd 12
31/08/2009 1:18:15 PM
