Setting the pulse stretching
If the web speed is high and the splice width is thin, the signal on the switching
output is very short when moving over a splice.
– Therefore a fixed pulse stretching of 20 ms is activated in the factory set-
tings.
– If pulse stretching is undesirable, you can switch the function off.
3
Ä
Press the teach button until the green ON LED and the yellow OUT LED flash
alternately.
Ä
Release the teach button.
ð
The green ON LED flashes for another 2 seconds and the yellow OUT LED
indicates the changed status of the pulse stretching for 2 seconds:
OUT LED ON: pulse stretching activated
OUT LED OFF: pulse stretching deactivated
Adjusting the switching behavior of the switching output (light/dark
switching)
4
Ä
Press the teach button until only the green ON LED flashes.
Ä
Release the teach button.
ð
The green ON LED flashes for another 2 seconds and the yellow OUT LED
indicates the changed switching behavior for 2 seconds:
Yellow OUT LED ON: switching output, light switching (signal on the splice)
Yellow OUT LED OFF: switching output, dark switching (signal on the web)
8
EN
