Reflectors
32
AMS 384
i
Leuze electronic GmbH + Co. KG
6.4
Mounting the reflector
6.4.1
General information
Self-adhesive reflective tapes
The reflective tapes of the "Reflective tape …x…
-
S" series (self-adhesive) must be affixed
to a flat, clean and grease-free surface. We recommend using a separate carrier plate, which
is to be provided on-site.
As described in Table 6.1, the reflective tape must be at an angle.
Reflective tapes on carrier plate
The reflective tapes of the "Reflective tape …x…
-
M" series have corresponding mounting
holes. Spacer sleeves are provided to enable mounting at the necessary pitch angle. For
further information, see Table 6.1.
Heated reflectors
The reflective tapes of the "Reflective tape ...x...
-
H" series have corresponding mounting
holes. Due to the voltage supply affixed on the rear, the reflector cannot be mounted flat.
Four spacer sleeves in two different lengths are supplied. Use the spacer sleeves to ensure
separation from the wall as well as to provide the necessary pitch for avoiding surface reflec
-
tion. For further information, see Table 6.1.
The reflector has a 2m-long connection cable for supplying with 230VAC. Connect the cable
to the nearest power distribution point. Observe the current consumptions listed in the tech
-
nical data.
Attention!
Connection work must be carried out by a certified electrician.
6.4.2
Mounting the reflector
The combination of laser measurement system and reflective tape/reflector is mounted so
that the laser light spot hits the film as centered as possible and without obstruction.
For this purpose, use the alignment elements provided on the AMS 384
i
"Mounting the AMS 384i"). If necessary, remove the protective film from the reflector.
Attention!
The "TOP" label on the reflectors should be aligned the same as the connections of the
AMS 384
i
.
Example:
If the
AMS 384
i
is mounted so that the M12 connections are on the top, the "TOP" label of
the reflector is also on the top. If the
AMS 384
i
is mounted so that the M12 connections are
on the side, the "TOP" label of the reflector is also on the side.
