Leuze
electronic
Short instructions IT 6300
Leuze
electronic
Page
4
Connecting the cable for the IT 6300
1. To secure the interface cable to the scanner, proceed as follows: plug the RJ 41 connector into the
socket on the bottom of the hand-held scanner, now use a Phillips screwdriver to secure the supplied
clip for locking the cable.
2. Connect the interface cable to the appropriate connection socket on the computer.
3. You will need a power supply unit for the voltage supply. Connect this power supply unit to the interface
cable.
4. Connect the power supply unit to the power socket.
5. Check the operational readiness of the scanner by pointing the scanning surface towards a flat surface
and pulling the trigger. A green target line as well as the red illumination should now be visible. Now
scan a sample label. The scanner emits an audible signal to confirm that the label has been read; if
necessary, the data are now passed on to the computer.
Testing the scanner
The adjacent bar code is for testing the scanner,
the module size is 0.5 mm (20 mil)
Code 39 bar code sample
Specifications
The technical data can be found in the data sheet for the IT 6300.
Pin assignments of the connection cable
TTL-RS232 cable/ext IT 6300 Part No. 501 05422
Pin assignments of the 9 pin D-sub socket (female) for cable 42206139-04
Pin number
Signal
Designation
1
Shield
Shield
2
TX
Transmit data
3
RX
Receive data
5
GND
Signal ground
7
CTS
Clear to send
8
RTS
Request to send
Pin at power supply unit
connection
Signal
Designation
1
VCC IN
4.5…12 V DC
2
GND
Ground
The proper power supply unit for the IT 6300 (230V/50Hz) has part no. 501 03403.
