Mounting
Leuze electronic
DDLS 508
29
4.3.2 Vertical mounting (lifting axis) without alignment laser
Mount the two devices opposite one another with a lateral offset of 30 mm.
Place an alignment straightedge or level on the lateral support edge of one of the devices.
Move the devices towards one another horizontally so that there is an offset of 30 mm between them
(see figure 4.10). The transmitter of one device is positioned opposite the receiver of the other device.
1
Lateral offset 30 mm
Figure 4.10: Lateral offset of the devices with vertical mounting
Determine the horizontal mounting position of both devices.
Place an alignment straightedge or level on the planar support surfaces in the connection area of both
devices.
Move the devices until both are flush with one another. To do this, use the vertical level of a bubble level.
Mounting of the device is concluded.
Further procedure:
• Connect the devices electrically (see chapter 5 "Electrical connection").
• Perform the fine adjustment for the lifting axis (see chapter 6.2 "Fine adjustment").
30 mm